Model #: 8680211760379
Unit of Measure: SET
Quantity Per Unit: 1
Minimum order: 1
Order Increments: 1
1'' ID (#7.5) two-step hole cutting piercing & grommet attaching setting die. Compatible with ClipsShop CS-TIDY-51, CS-TIDY-41, CSBUR-1, CSTEP-2, CS-PIC-2 grommet attaching machines
1 dies, 2 steps. No need for two separate dies. Reduce work in process & increase productivity. Designed to minimize the force required during use for greater application comfort
For the 1st step, place a washer on the lower die, insert your material, and cut the hole through the fabric. Next, without moving the position of the substrate, place the grommet on the lower die directly over the hole. Make a second cycle or impression with your grommet machine press and set the grommet through the hole.
Rather than falling in the way, the scraps of fabric collect in the upper die. After attaching approximately 15–20 eyelets, remove the stack of pieces from the upper die and continue setting non-rusting brass ClipsShop metal grommets
This carefully engineered stainless steel grommet attaching die is a combination that in two steps, with the single die, will first pierce a hole in the material first as a cutter die and in a second step with the same die (without removing it from the grommet press attaching machine, the grommet attacher die will set the grommet into the material, without the added expense of two separate dies and at a drastically reduced labor cost!