Inside diameter: 3/8"
Flange diameter: 0.75"
Neck length: 0.31"

#2 Long Neck 9mm Chemical Black Oxide brass ClipsShop metal grommets and washers with 3/8" ID hole size, 500 pieces of each.


You can apply the #2 3/8" .375 ID hole size grommet with the following ClipsShop machines:

• CS-TIDY-41
• CSTEP-2
• CSTON-1
• CSTEP-1
• CSHAP-1
• CS-TIDY-51
• CS-BUR-1
• CS-PIC-2
• CS-PIC-3

Note: Our ClipsShop brand grommets fit our ClipsShop brand self-piercing stainless steel dies. They have also been known to fit on certain Micron and Stimpson dies. Micron calls 3/8" ID grommets a #2. If you have an existing Micron #2 die then you should order our #2 grommets to fit it. If you plan on using our grommets with a different brand of machine, we suggest you request free samples for testing before making a purchase. Open bags of grommets may not be returned. If you have a Hiker hand press, please contact us about a special die adapter so you can apply our ClipsShop grommets with your Hiker hand press.

Note: ClipsShop #2 long neck grommets have the same 3/8" - 0.375" hole size as a #2 grommet but they have a longer neck length for thicker material such as corrugated plastic, coroplast, foam board, gatorboard, and foam core. See the grommet chart for more size information and to buy grommets.

While the #2 long neck 3/8" hole size grommets are self-piercing, it is strongly recommended that you pre-punch a hole. Without a pre-punched hole, you may crush your material if you are not careful. The grommets will pierce most materials but with a pre-punched hole, you can avoid any crushing. Thank you.
 

Alternate Part Numbers associated with this product: #2LN GWB and CSGBO-2LN.